Full product range & more information:
www.lumenalights.com
OLYMPIA TECHNOLOGY:
The Olympia is a highly efficient solar light with high capacity LiFePO4 Lithium batteries and a fast charging Monocrystalline solar
panel. This means that even on cloudy and rainy days, it will re-charge efficiently. The high battery capacity gives enough power
for up to 23 hrs solid light (approx. 2-3 nights) even when there is little light during the day. The high lumen light output is bright
enough to illuminate driveways and paths, making them safe to navigate at night, with a downward spread light projection.
INSTALLATION:
Designed to be mounted on a low wall, wood, patio or set in concrete (J-Bolts sold separately) via the external surface mount.
Recommended spacing is 3m apart for substantial lighting. Closer spacing / staggering will result in a more
intense light.
Location
–
It is important that the installation location is carefully considered, avoiding
shady areas. Ensure there is no other lights which could interfere with the light, imitating
daylight and forcing the light off.
1.
Use the base to mark the mounting holes on the mounting surface in the desired
location.
2.
Remove the light and drill out the 3 holes marked at the relevant depth and
diameter for the mounting screws / wall plugs being used (varies based on
mounting surface)
–
Anchor bolts recommended.
3.
Replace the pedestal light, lining up the 3 x holes at the base and secure in place
with the chosen screws / bolts - large washers may be required.
Do NOT overtighten.
NOTE: MAX SCREW DIAMETER = 12MM
–
ensure long enough to clear 20mm depth of base.
IMPORTANT:
Spacers may be beneficial between the surface and underside of the mounting base (20mm), depending on
which type of fixing bolts are used. This will prevent overtightening of screws and potential strain / damage to the base.
TIP:
If hexagonal coach bolts are used, use black dome covers to conceal the head of the bolt.
SETTINGS:
The Olympia has a pre-set time controlled setting which cannot be changed. At dusk, the bollard will illuminate at full brightness,
and then follow a gradual dimming sequence until it reaches 30% brightness after 5 hours. From then on it will remain at 30%
until dawn. This sequence is to ensure the maximum charge is retained.
IMPORTANT
–
SOLAR PEDESTAL LIGHT MUST BE TURNED ON AT ALL TIMES AFTER INSTALLATION
If the pedestal light is left in the off position, you may be prompted to turn the fitting on by strobing.
Solar pedestal will only charge when in the ON position.
Turning on the pedestal light
1)
Remove the waterproof rubber bung located just below the polycarbonate lens, in line with the Lumena Logo, to locate
the red on/off button.
2)
Using a small, flathead screwdriver (or similar), push the on button inwards until it clicks and allow to pop back out
(this will be partial). The pedestal is now in the ON position.
3)
Replace the waterproof, rubber bung.
4)
To turn off for storage, repeat the same procedure as above.
NOTE:
There will be a 2-5 second delay between turning the solar light on, and the pedestal illuminating. In daylight, the light
will turn back off within a few seconds, in darkness it will remain on and follow the time-controlled cycle.
STORAGE:
When storing the pedesatl, be sure to turn the bollard to the off position by following the above steps (check by covering and
uncovering the solar panel). Once pressed, the on/off button will release fully forward. Maximum 6 months storage when fully
charged
–
recharge will be required periodically to prevent damage to battery over long periods of time.
Depth 20mm
100mm
13mm
185mm
130mm
