Full product range & more information:
www.lumenalights.com
Light
Fittin
g
N
L
Live Cables
Earth
Cable
Mains
Power
Cable
Neutral
Cables
Earth Cable
Earth = Yellow &
Green
Neutral = Blue
Live = Brown
INSTALLATION:
•
Remove the front plate by unscrewing and removing the 3 x cross head screws.
•
Using the pre-drilled holes in the back mounting plate, mark drill holes in the desired mounting location. Note: ensure
the fitting is mounting the correct way as marked with an arrow pointing up.
•
Drill correct size holes where marked and insert plugs if required (M3 - M4 screws recommended).
•
Power cable can either be connected and threaded through a drilled out hole in the mounting surface or secured
externally (conduit recommended).
•
Wire the fitting to the mains power supply (see below for wiring / connection).
•
Screw the mounting plate (back) to the surface using 2 x M3 or M4 screws. Ensure no cables are trapped between the
surface and mounting plate.
•
Install LED bulb (see below for more information).
•
Replace the front plate and secure in place with the 3 x cross head screws removed initially, ensuring the seal is
correctly in place between the face plate (front) & mounting plate (back).
WIRING / CONNECTION:
Always use a waterproof Junction Box or Tubecon Connector to connect the fitting to the mains power supply.
IMPORTANT: Cable should be laid inside armoured conduit or piping to
protect from water-logging, chemicals found in soil and damage. If buried,
it should be buried to at least 0.5m below ground to reduce damage risk.
If this method is not used, cable warranty will be void
•
Locate the mains electrical supply (pre-installed armoured cable).
•
Ensure the mains power is switched off.
•
Connect the fitting to a connector block located inside a waterproof
junction box or a single waterproof in-line connector such as the Tubecon
(sold separately)
•
Ensure all terminals of the connector block are secure with no stray wires
and that the connection is watertight.
•
Seal the junction box to ensure a watertight seal
•
Once fully installed, turn on the mains power.
LAMP INSTALLATION / REPLACEMENT:
•
Remove the front plate by unscrewing and removing the 3 x cross head screws.
•
Insert G9 lamp (push action). Ensure the bulb is straight when installed to avoid damaging the pins. If you are finding this
difficult, the bulb holder can carefully be pulled forwardly slightly and then returned to the original position.
•
Replace the front plate and secure in place with the 3 x cross head screws removed, ensuring the seal is correctly in
place between the face plate (front) & mounting plate (back).
IMPORTANT:
Condensation may occur due to the warmth inside the fitting produced by the lamp and the cold air outside. If
this is noticed, on a dry day, turn off the power supply, safely remove the front plate and wipe dry with a soft cloth. A silica gel
pouch can be left inside the fitting to soak up any excess moisture if required.
TROUBLESHOOTING:
If for any reason the fitting does not work after installation, please follow the below steps safely (power supply must be off):
•
Check that all connections are correct and secure
•
Check the cable for damage
•
Change the LED bulb, double checking that it does not exceed the maximum wattage
If the fitting stops working after a period of time, please follow the above steps with the addition on the following:
•
Check the fitting and the junction box for damage or water ingress
If none of the above rectifies the issue, please contact us for further assistance.
