P30P-09A 17 User's manual
To accept the set parameter, press the following button:
. The parameter will be
saved. Pressing the following button:
while changing the parameter value will cancel the writing.
5.4.2. Changing the floating-point values
The change is done in 3 stages (to move to a next stage press the following button:
).
●
setting the decimal point (00000., 0000.0, 000.00, 00.000, 0.0000);
button moves the
point to the left, while
button moves point to the right. Pressing the following button:
while changing the parameter value will cancel the writing.
●
setting the value from -99999…99999 ranges for the normal values;
●
setting the order of magnitude x1, x10
3
, x10
6
, x10
9
(symbols „k”, „M” and „G” for orders of 10
3
,
10
6
, 10
9
respectively are displayed)
5.4.3. Programmable parameters of the transducer
The following table shows the programmable parameters and the range of their values.
Table 1
Settings
Input
Parameter symbol
Description
Range of changes
Input type
Input current range selection
230V, 5A
Input
range 5A
(version P30P
-2xxxxxxxxx)
230V, 1A
Input
range 1A
100V, 1A
Input
range 5A
(version P30P
-1xxxxxxxxx)
100V, 1A
Input
range 1A
Measurement type
Measurement result
interpretation method
1 phase
1-phase measuring system
3 phase
Simulation of a symmetric 3-
phase system (power and energy
values multiplied by 3)
DemandTm
Synchronization of the
average active power,
average apparent power and
average current
Mov.Wind
15-minute stepping window, no
clock synchronization
15 min
Measurement synchronized with
the clock, aggregation time of 15
minutes
30 min
Measurement synchronized with
the clock, aggregation time of 30
minutes
60 min
Measurement synchronized with
the clock, aggregation time of 60
minutes
Averag.
Instantaneous values
averaging
no
No averaging, instantaneous
value is synchronized with
