.07.
Owner’s Manual & Safety Instructions
Impact driver
Rotational Direction Switch
: Before adjust rotational direction
switch,the tool must be switch off.
Right Rotation:
For drilling forward,push the rota-
tional direction switch left to the stop.
Left Rotation:
For drilling backward,push the
rotational direction switch right to the stop.
: The rotational direction switch is
used to reverse the rotational direction of the ma-
chine. However, this is not possible with the
On/Off switch actuated.
Adjusting the Speed
The speed of the switched-on power tool can be variably adjusted, depending on
how far the On/Off switch is pressed. Light pressure on the On/Off switch results
in a low rotational speed. Further pressure on the switch results in an increase in
speed.
Protection System
This system automatically cuts off power to the motor extend tool and battery
life.The tool will automatically stop during operation if the tool or battery is placed
under one of the following conditions:
Overload Protection
When the tool is operated in a manner that causes it to draw an abnormally high
current, the tool automatically stops without any indications.In this situation, turn
the tool off and stop the application that caused the tool to become overloaded.
Then turn the tool on to restart.
Overheat Protection
When the temperature of the machine is overheated, the machine stops auto-
matically. In this situation, let the machine cool before turning on again.
9.Maintenance
a.To prevent accidents, always switch off the tool before cleaning or performing
any maintenance the saw may be cleaned most effectively using compressed
air. Always wear safety goggles when using compressed air. If compressed air is
not available, use a brush to remove dust and chips from the tool.
