Lumberjack WB1620, Safety And Operating Manual, Page: 6 / 11

WB1620 04
ASSEMBLY
6.Set the Sliding Partition (14) into place by
inserting the tabs at the end of the Partition into
the holes at the center of the Table Top’s
underside.
Note: Verify that the Sliding Partition and Table
Top face the same direction.
7.Use the Screws (13) to fasten the Sliding
partition to the middle of the Table Top’s
underside.
Note: There are no pilot holes available for this
step, so you will need to use a drill to make the
pilot holes before threading in Screws.
8. Using assistance, set the assembled Legs and
Shelf onto the underside of the Table Top.
Note: Verify that the Drawer guide slots on the
Sliding Partition face the same way as the Drawer
guide slots on the Legs.
9. Use the Hex Wrench and Screws (6) to fasten
the tops of the Legs to the Table Top underside.