Lumberjack TS254SE, Original Instructions Manual

Page: 7 / 25

TS254SE 05
GENERAL POWER TOOL SAFETY WARNINGS
9.5 Be sure that the laser beam is aimed at a
work piece (such as wood or a rough‐coated
surface) that does not have a reflective
surface.
9.6 Do not use on materials that have shiny,
reflective surfaces, such as sheet metal.
The reflective surface could reflect the beam
back at the operator. Be aware that laser light
reflected off of a mirror or any other reflective
surfaces can also be dangerous.
9.7 Always wear laser‐protective eyewear
when working on or near reflective surfaces.
9.8 Do not attempt to activate the laser when
the tool housing is removed.
9.9 The laser is activated by means of a
button switch that is independent of the main
switch for the saw.
9.10 Do not replace the laser light assembly
with a different one.
Any repairs must be
carried out by the laser manufacturer or an
authorized service agent.
9.11 Do not attempt to repair the laser guide
by yourself.
9.12 Do not attempt to change any parts of
the laser guide.
10. Using an Extension Cable
.
10.1. If an extension cable is required, use an
approved triple core extension cable suitable for
the power input of the tool.
10.2. Grounded tools always require a three wire
extension cable.
10.3. As the distance from the supply outlet
increases you must use a heavier gauge extension
cable. Using extension cables with inadequately
sized wire causes a serious drop in voltage,
resulting in loss of power and possible tool
damage.
10.4. The smaller the gauge number of the wire
the greater the capacity of the cord.
10.5. When using a cable reel, always unwind the
cable completely.