PS240 07
ASSEMBLY INSTRUCTIONS&OPERATION
Wrap the sandpaper under the cushion (6), lift the
opposite lever, and insert the loose end into the
paper clamp.
Return the lever back to its position over the tab to
secure the new sandpaper sheet into place.
Operation
Switch ON/OFF
Warning! Never switch on the sander whilst the base is
in contact with the workpiece or any other surface as
this may cause the operator to lose control over the
tool and could result in serious injury.
Caution: Always hold the sander securely by the soft
grip surface(2).
Connect the sander to the mains power supply. To start
the tool, press the ON/OFF switch(1) to the ON
position.
To stop the tool, press the ON/OFF switch(1) to the OFF
positon.
Warning! Always wait until the tool has stopped
vibrating completely before putting it down. Always
disconnect from the power supply after use.
Cleaning/Emptying Dust Box
TO maintain performance of the sander the dust
collection box(9) and filter will need cleaning regularly.
To access the filter pull the top part of the dust
collection box away from the bottom.
Rinse the bottom half under clean running water and
dry thoroughly.
