Lumberjack BGS125, Safety And Operating Manual

Page: 12 / 21

B GS125 10
OPERATING INSTRUCTIONS
WARNING! KEEP TOOLS AND EQUIPMENT
OUT OF THE REACH OF YOUNG CHILDREN
CONNECT THE WET &
DRY GRINDER TO THE MAINS
SUPPLY.
ALWAYS WEAR EAR DEFENDERS AND
SAFETY GOGGLES.
Carry out final checks e.g. check the gap between the tool
rest and the stone is correct, check the stones are not badly
deformed (rounded edges, grooved face, etc; unless you
have specifically shaped the stone to these profiles), check
the eye shield is correctly positioned. Have a cooling pot to
hand if you need it. Fill the water container (L) to a level
about 15-20mm below the lip of the container, see fig 01
1
Fill with water
Container lip
2
Mark the bevel with a marker to allow you to see where
the grinding will occur.
The most common secondary bevel is 30° when the main
body of the tool is ground at 25°. The chart below gives
you some guidance as to which angle is most suited to
which materials.
Place the tool into the jig (N) around half way along the
blade and position it against the jig’s stops, see fig 3.
Tighten the clamping knobs. Slide the assembly onto the
universal bar (M), see fig 04.
3
4 M
Stop
N
L