PT330B 10
MAINTENANCE AND SERVICE
–
Remove gib using magnets provided.
CAUTION:
Blade edges are extremely sharp. Keep
fingers away from blades at all times.
–
Blade is located in position by two pins. Gently lift
old blades from cutterhead using magnets. Do not
make contact with the blade using fingers. Use
magnet only.
– Reverse or replace blade and carefully position
it on the two pins using magnets.
– Replace gib and align the holes on the gib with
holes on the blade using magnets.
– Secure gib to cutterhead using six bolts
removed earlier.
Gib bolts
Brush inspection and replacement
WARNING: Turn planer off and disconnect from power
source. Brush life depends on amount of load on
motor. Regularly inspect brushes after 50 hours of use.
Brushes are located on either side of planer motor.
– Loosen brush cap and carefully remove brush
from motor.
– Replace brushes if carbon is worn.
– Replace brushes and tighten brush caps.
Brush cap
