Lumatek Zeus 1000W Pro, Manual

Page: 8 / 65

6.3
6.5 Connecting the manual dimmer or external lighting controller
The dimmer control or lighting controller is connected to the ‘SIG IN’ connector on the fixture frame.
This enables light intensity (PPF output) to be adjusted according to requirement. The LED fixture light
intensity can be adjusted without changing relative spectral power distribution or losing efficiency.
Remove dust cap and ensure male & female connectors are correctly aligned and then push together
until click-locked. To disconnect; turn twist-lock anti-clockwise and pull apart.
6.4 Installing the fixture
Warning! Mount the system to something that can hold the weight of the LED fixture.
Ensure all light bars are installed correctly and are secure.
Carefully turn the fixture over and attach the metal cable hangers to the mounting hooks.
Hang the fixture in required position and height.
For optimal performance; position fixture 50 -100cm above plant canopy for a 1.5 x 2m light spread.
Ensure the fixture is hung horizontally.
The LED fixture’s modular design uses intelligent LED drivers which can decrease or increase power to
match the amount of 100W light bars installed on the fixture automatically. If not all light bars are required,
the drivers will only draw power required for the amount of light bars connected eg if six light bars are
connected the drivers will only draw 600W to power them.
Warning! At least one light bar must be installed in the fixture before switching on.
Attach cable hangers
to mounting hooks.
Connect manual dimmer cable or lighting
controller cable to SIG IN port (left socket).
Changing and replacing light bars and modular use