IN0025 - 6 August 2014
Copyright ©2014 Lumascape Lighting Industries Pty. Ltd. ABN 21 010 572 773
www.lumascape.com.au
Base of luminaire
4x Screws/Bolts and Washers
to suit Ø8 mm hole required
2x screws to suit Ø5 mm hole required
Hole Centres 110 mm Square
150 mm Square
1220 mm
450 mm
Saddle
Conduit
Supply Cable
Mounting Stud
4x Screws/Bolts and Washers
to suit Ø8 mm hole required
Turnbuckle
Turnbuckle
2x Screws to suit 5 mm hole
1.
2.
3.
4.
LS6025 - signage system accessory
1. Drill/cast holes and run cables as per lighting plan. Cable will need to exit the mounting surface
into the hollow of the signage pole.
2. Use discretion in placement as luminaire can become very hot and may burn.
3. Select/purchase appropriate stainless steel fasteners for mounting substrate. (Not supplied.)
1. Feed supply cable through pole until exiting mounting stud at the end.
2. Bolt signage pole to wall.
3. Open turnbuckle to approximately half of it’s adjustment range. Extend the rope assembly up the wall and fasten saddle in place.
4. Fit rope assembly to saddle and lightly adjust tension if required.
Remove base from luminaire and feed through
supply cable.
Screw luminaire base onto mounting stud.
Terminate supply cable.
Adaptor Base for Signage
NOTE: Use only 1 x circular
cable to keep IP rating