INSTALLATION INSTRUCTIONS
Lumascape Lighting Industries Pty Ltd
38-44 Enterprise Street, Cleveland, QLD 4163, Australia
PO Box 1875, Cleveland D.C., QLD 4163, Australia
T
07 3286 2299
F
07 3286 6599
E
W
www.lumascape.com.au
IN0025 - 6 August 2014
Copyright ©2014 Lumascape Lighting Industries Pty. Ltd. ABN 21 010 572 773
www.lumascape.com.au
DANGER
ISOLATE LUMINAIRE FROM POWER
Failure to isolate power
supply before installation or
maintenance may result in
fire, serious injury, electric
shock, death and may
damage the luminaire.
Luminaire can become very hot.
Use discretion in placement.
Ensure that installation complies
with local authority standards.
All connections must be kept
dry; failure to do so may result
in product reliability issues.
Screw seals and sleeve must be
fitted or warranty void.
WARNING
LS6023
(ordered separately)
LS411
Surface Mount
Base
LS411
Adaptor Base
LS6025
(ordered separately)
OR
OR
LS411
Concrete Anchor /
Spike
Select Mounting Option
See individual mounting accessory
instructions overleaf
1.
Power supply must be
isolated prior to connection
or disconnection of cables.
2.
Terminate luminaire. Single colour, non-dimmable, mains-voltage
version depicted in example. Refer to wiring diagrams below
for details. Earth lug connection only required for mains voltage
version of luminaire.
Select the grommet to suit wiring conductors. For correct cable selection refer
to table on top right. Screw mounting base to mounting accessory or screw
directly to mounting surface using 4 screws provided (holes for mounting
screws may be supplied blind. Drill through as required with a 4.5 mm drill. A
screw must be used for each hole drilled to achieve IP67 rating.)
Surface Mount Base
IMPORTANT
For All Mounting Options
Select a suitable power supply and locate centrally in relation to desired luminaire locations.
Use discretion in placement as luminaire can become very hot and may burn. Run conduit
and drill / cast holes as specified. Run cables. Maximum distance for remote drivers is 30 m
from the luminaire. Use table on right to select a suitable supply cable with the appropriate
number of conductors for the luminaire you are installing.
Luminaire Type
No. of supply cores needed
Single colour, low-voltage, non-dimmable
2
Single colour, low-voltage, dimmable
4
Single colour, mains-voltage, non-dimmable
3
Integral RGB driver
6
Remote RGB driver
6
E
Earth lug only required
for mains voltage
NOTE: Use only 1 x circular
cable to keep IP rating
SPOTLIGHT & FLOODLIGHT
LS411LED
Omnio Mini
Warranty void if not installed as per installation instructions
N653
MODEL
LS411LED
INSTALLATION TyPE
Surface Mount Base
Pole Clamp (LS6023)
Signage System (LS6025)
Concrete Anchor / Spike
IP RATING
IP67
SUPPLy VOLTAGE
100-240 V AC, 50/60 Hz
24 V DC Ripple Free Supply
12 V AC Magnetic Transformer
INSTRUCTIONS COVER
Single Colour
Single Colour Dimming
RGB (Integral & Remote Driver)
NO POWER
TOOLS
KEEP AWAY FROM
FLAMMABLE MATERIAL
DO NOT USE SILICONE
ON OUTSIDE SURFACE
KEEP ELECTRONICS FREE
FROM DIRT AND MOISTURE
DO NOT HOSE OR
PREASSURE CLEAN
see over for wiring diagrams
