2
LED Self –Driven Lightbar
Wiring Diagram
Turn off electrical power at fuse or circuit breaker box before wiring
fixture to the power supply.
1.
For applications utilizing 13E807:
2.
Connect remaining Lightbars using supplied joiner accessory, connection cords sold
separately.
3.
Please note, your bar shipped with two end caps to cover unused plug receptacle.
Please complete your installation by covering the unused receptacle.
Warning,
the exposed end of a lightbar can be energized if the bar has been plugged in to a
power source. Make sure that you do not touch this area and to cover prior to use.
4.
Plug 13E807 cord into outlet.
I
nstallation
1.
We recommend leaving a 1/8” gap between Lightbar and lip of cabinet or other permanent
structure for ease of installation.
2.
If applicable, secure installation clip to mounting surface by using supplied wood screw.
Use alternate fastener (not supplied) for other surfaces (i.e. molly bolts, concrete anchor,
etc.).
3.
(Optional) Use angle mounting bracket to direct light. Use screw or other fasteners to
secure clip to mounting surface. (Notches denote 30 to 60 degree angles)
4.
Press LED Lightbar into clip so it secures firmly. Gently pull on Lightbar to verify proper
installation.
5.
When using supplied bar to bar joiners, make sure joiner is firmly inserted into both ends.
No gaps should exist between the bars.
6.
When using double sided tape, make sure mounting surface is free of dust and debris to
ensure proper adhesion. Apply tape to back of LED Lightbar and press Lightbar to
mounting surface firmly.
** Surface for double face tape must be appropriate (sealed non-porous), and the user has to
confirm this.
Warranty
LIMITED FIVE-YEAR WARRANTY
Should this product fail to perform satisfactorily due to a defect or poor workmanship within FIVE
YEAR from the date of purchase, return it to the place of purchase and it will be replaced, and
free of charge. Incidental or consequential damages are excluded from this warranty.
LumaPro Operating Instructions
13E803 thru 13E804