Lumag CNCJ-72FW, Operator'S Manual

Page: 17 / 25

16
CNCJ-72FW CNCJ-80K – OPERATION
This section is intended to assist the operator with the initial start-up of the CNCJ-72FW
CNCJ-80K Tamping Rammer. It’s extremely important that this section be read carefully
before attempting to operate the rammer.
DO NOT use your rammer until this section is thoroughly understood.
Read Manual!
Failure to understand the operation of the CNCJ-72FW CNCJ-80K Tamping Rammer
could result in severe damage to the trowel or personal injury.
Rammer Gearbox and Spring Cylinder Oil Bath
This unit uses an oil bath lubrication system. Perform the following:
1. Check the oil level through the oil level sight glass (Figure 2) at the rear of the tamper
foot.
Figure 2 Foot Housing Sight Glass
2. If oil is not visible, add 10W-30 motor oil into the oil fill plug opening (Figure 2). The
bath contains approximately 1.7 pints (800 cc.).
The oil level should be kept at the half way point of the sight glass.
Engine
1. Fill the fuel tank (Figure 3) with unleaded gasoline. At the same time, check the
engine oil and make it a habit to replenish it often.
NOTE CAUTION