3
31212010
Transfer Carriage Rear Tilt Cylinder Lug Repair Instructions
For Kit 1001182758
1.7.3
MOUNTING LUG MACHINING
1. The mounting lug will require drilling and/or
machining. This operation can be performed in house
if the proper equipment is available. If not, a
reputable machine shop will be required to perform
the machining.
2. Refer to Section 1.10. "Mounting Lug Machining" for
exact machining sizes and tolerances.
3. Drill and ream a new hole in the new transfer carriage
rear tilt cylinder mounting lug (
1
). (Refer to Section
1.10. "Mounting Lug Machining")
4. Clean, prime and paint the affected areas.
1.8
TRANSFER CARRIAGE REAR TILT
CYLINDER ASSEMBLY
1. If required, replace all damaged transfer carriage
slave cylinder components.
2. Reassemble all components incorporating new
Spherical Bearing P/N 8050001, Pin P/N 10136464,
Keeper Rod P/N 3841709, Grease Fitting P/N
10715272 and Cover P/N 10732689.
3. Refer to the appropriate service manual for detailed
assembly procedure.
4. Remove all protective coverings from any hoses,
wires and hydraulic cylinder rods.
5. Properly connect the battery.
6. Load the unit with the rated capacity and cycle the
boom functions throughout their full range a minimum
of five times to ensure safe and proper operation.
7. Inspect the repair areas for discrepancies.
8. If equipped, close engine access door.
9. Remove the Do Not Operate Tag from the ignition
key switch and the steering wheel.
10. Return machine to service.