TableofContentsdkadfkcheuqhcdlzkeican
How To Set & Segment Messages
Trouble Shooting_When It Does Not Work
User’s Manual ... 13
12... User’s Manual
7
8
Charge / Discharge Time
By Battery Capacity
9
- Check if the power switch is on.
- Press the key to check the segment LED works. If the segment LED does not work,
the battery voltage of the device might have dropped to below 9V. Apply the main power.
- Make sure the DC source power connector is properly inserted.
- Check if there is any disconnected power cable or connector.
Check with alternative cable or connector. (Required fuse type is 5A, 250V)
- If you still cannot solve the problem, please contact either the seller or A/S center.
Status
Normal
Display of battery
charging status
Display of
input voltage
Display of
output voltage
When input
power is
connected
When input
power is not
connected or
power switch
is off
Key
Numbers
of Clicks
Operation
Segment Message
1
1
1
MODE
ENTER
Display of
cut-off voltage
Save the cut-off
voltage
Change of
cut-off voltage
12.4 ~ 11.6
1
(3 sec)
MODE
1~6
c 12.4 ~ c 11.6
After entering
cut-off menu,
SELECT
After changing
cut-off settings,
ENTER
1
Operation of
the device
All Keys
1
Display of
residual battery
capacity
After the normal
operation,
MODE
1
Display of
output voltage
After the normal
operation,
ENTER
Battery Capacity
Charging Time
Discharging Time
2,600mA
approx. 2.0 hours
approx. 8~9 hours
3,000mA
approx. 2.5 hours
approx. 10~11 hours
※ Charge/discharge time is calculated based on 1 blackbox use.
(On the basis of current consumption of 200mA)
※ Charge/discharge time may differ depending on the power consumption of blackbox.
※ The batteries can discharge with the cut-off voltage of 12V or below, depending on the vehicle's battery status.
