20
Removal and replacement of main frame pawl spring #200
To remove main frame pawl and pawl shaft:
1. Remove snap washer by placing screw driver point at each end and
force out of groove.
2. Drive out main frame pawl shaft from the small hole end.
3. The main frame pawl, spring and shaft are then free.
Note: On a main
frame pawl replacement the spring anchor pin is included and sup-
plied attached to the new pawl.
➀
➀
SWING U FRAME AWAY FROM SPRING IN FIG. 1 & 2
➁
LOOP SNAPS OFF PIN, PUSH HERE TO REMOVE
➂
INSERT SPRING BETWEEN RATCHET & MAIN FRAME AS SHOWN
➃
SWING U FRAME TOWARD SPRING & PRESS DOWN
➄
WITH LOOP SNUG
➅
UNTIL THIS LOOP SNAPS ON ANCHOR PIN
FIG.2
FIG. 3
TO INSTALL
FIG. 1
TO REMOVE
➀
➀
➁
➂
➃
➄
➅
To replace main frame pawl and main pawl shaft:
1. Place frame so the name LUG-ALL cast on the side at the top is on
left.
2. Place loop of spring at #1 end on spring anchor on the main frame with
the hoop of the spring between the ratchet wheel and the frame.
3. With trigger end of pawl toward you, place spring anchor pin in loop at
#2 end of spring.
4. Pressing down on the pawl align the hole with those in the frame and
insert the shaft, shouldered end first.
5. Replace the snap washer.
To replace main frame pawl spring #131:
1. Place #2 end of spring between ratchet wheel of drum and the main
frame, with the large hoop of the spring facing #1 hook position.
2. Hook the loop on the #2 end over spring anchor pin on the main frame
pawl.
3. Place screw driver in loop at #1 end, then draw beyond the spring
anchor on the main frame.
4. Ease tension on the spring so the #1 end will be secure on the spring
anchor on the frame.