11
LR600
Calibration Adjustment
Z Axis Adjustment
1.
Set up the LR600 so that the Z axis (vertical line) aligns with a vertical plumb line.
2.
Activate calibration adjustment mode as described previously.
3.
Press the X / Y button on the remote control 3 times. The Z
LED on the calibrate panel will illuminate as shown on the
right. The laser head will start rotating and the Z axis can
now be adjusted.
4.
Adjust the position of the beam using up down buttons on
the remote control until the desired position is achieved.
5.
To save the new setting press ENT button on the remote control. The Z axis LED will now
turn off.
Note When calibration is complete, switch the LR600 off completely before using it further.
