ventus
Operating Manual V16/05.2016
22
G. Lufft Mess- und Regeltechnik GmbH, Fellbach, Germany
11 Commissioning
After the equipment has been installed and connected correctly, the sensor begins
autonomously to take measurements. A Windows
®
PC with serial interface, UMB-Config-
Tool software and interface cable (SUB-D 9 pole; jack - socket; 1:1) are required for
configuration and test purposes.
Attention must be paid to the following points:
Check for correct equipment operation on site by carrying out a measurement with the
aid of the UMB-Config-Tool (see page 27).
The device must be aligned to the North in order to ensure correct wind measurement
(see page14).
If several
ventus
devices are operated on a UMB network, a unique device ID must be
assigned to each device (see page24).
There is no protective cover to remove on the sensor itself.
