Operating Manual CHM 15k
R13 / 07-2019
Communication via RS485 & Ethernet
51
Figure 19 shows the "Config Network" tab of a device with static IP in the default user view. In the super
user / service user view in the network configuration section (Figure 20 Web interface: Config Network
(service mode)), the static IP address (eth0: 1 custom), netmask, and gateway can be adjusted to the
local network conditions. To save the settings in the network configuration files and to use the new
settings, the network must be restarted. The restart can be initiated by clicking on the
“Restart network”
button.
Before switching on the AFD (ftp) mode, the AFD configuration file should be carefully installed. See 8.8
AFD mode for further information.
Figure 21
shows the contents of the "Config System" tab, which allows access to parts of the system:
Figure 21 Web interface: Config System upper part (service mode).
Filling out Location, institution, longitude and latitude is always very helpful if data are investigated and
compared with other instruments and if the Lufft support is required to identify any issues.
For safety reasons, some parameters in the superuser mode are not listed here. Further down on the
same page, firmware updates can be uploaded to the instrument in superuser mode (Figure 22). New
firmware files are packed as backup zip files and must be uploaded in this form. New firmware versions
are published on the Lufft website. A list of previously released versions is attached to this manual in
section 11.2.
Summary of Contents for CHM 15k
Page 1: ...General Information 1 Titelseite...
Page 73: ...Index of Tables 73...
