7
Installation to bait boat
1.Install the probe
Warning: Please do not install the probe near the motor of the boat. Otherwise,
the electronic noise caused by the motor and the bubbles generated by the prope-
ller will greatly degrade the sonar performance of the product. Generally recom-
mended to install at a distance from the bow of boat that the position of 1/3 of the
length of the bait boat. And ensure that the probe draft is not less than 10CM.
Note: For different bait boats, the installation method of the probe is also different.
The following is the probe installation guide for different types of bait boats on the
market:
1) A bait boat without a probe mounting hole in the hull
itself
There is no specific probe mounting groove at the bottom of these bait boats. So
you need to use tools to punch holes to install the probe on the bottom of the boat.
The following is the installation diagram:
probe installation Introduction
1）Choose a flat installation
location at the bottom of the
boat. Drill a hole with a diam-
eter of approximately 15 mm
at the selected position.
2）Assemble the probe and
waterproof rubber pad.（Factory
installed）
3） Pass the assembled probe
and rubber pad through the
probe hole.
4） Fix the probe with the lock
knob inside the boat then the
installation is completed.
Probe
Lock knob
No. 1 rubber pad
1
2
3
4
