Lucent Technologies Stinger, Administration Manual

Page: 98 / 374

4-2 Stinger® Administration Guide
Monitoring System and Network Processor operations
Maintaining ASIC Integrity
only-one-correction = yes
correction-factor = 5
auto-correction-enable = yes
interval-auto-correction = 600000
LIM automatic correction settings
By default, detection and correction of the LIM ASICs are performed every few hours
or at a specified interval. For earlier LIMs that are not equipped for integrity testing
(STGR-LIM-AD-12 and STGR-LIM-SH-48), the ASIC is simply reset automatically.
For recent LIMs that can perform integrity testing, instead of an automatic correction,
an integrity test is performed every few hours and the ASIC is corrected only if a
problem is detected.
Following are the integrity-config settings for LIM ASIC integrity testing, shown
with default values for a LIM in slot 1:
[in SYSTEM-INTEGRITY:integrity-config[1]]
enable-continuous-detection = no
detection-interval = 100
only-one-correction = yes
correction-factor = 5
Parameter Setting
enable-continuous-
detection Enable/disable detection and correction in continuous
mode. The default of
yes is recommended for the
control modules.
detection-interval
Detection interval in milliseconds. When continuous
detection is enabled, the control module performs
integrity tests at defined intervals. Valid values are from
0 to 65535.
Note The default value of 100ms is recommended for
control modules.
only-one-correction Enable/disable multiple corrections in a row. The
default
yes value causes the system to apply the ASIC
correction only once. Only one correction is
recommended.
correction-factor Number of problems that must be detected in the
previous 20 integrity tests to cause a correction. With
the default value of 5, a correction results if the system
detects five problems in its history of 20 previous tests.
Valid values are from 1 to 20.
auto-correction-
enable
Does not apply to control modules.
interval-auto-
correction
Does not apply to control modules.