3-8
Stinger® FS/Stinger FS+ Getting Started Guide
Determining the Operating Status
What’s next
Fan status lights
On Stinger chassis manufactured before late 2005, two fan status lights are located on
the rear of the chassis, on the right and above the holes of the air exhaust vent. These
lights indicate the operating status of the fans as described in Table 3-3.
Stinger chassis manufactured since late 2005 have a replaceable fan tray with a single
status light on the lower left side of the front cover. This light indicates the operating
status of the fans as described in
What’s next
Once the hardware installation is complete and the Stinger unit is powered up, you
can begin basic configuration as described in the following chapters, or download a
previous software configuration.
Table 3-3. Fan status lights - late 2005 and earlier
Status
light
Color
Condition
Indicates
POWER
Green
ON
The fan has power.
FAULT
Amber
ON
The fan is in a fault state.
Table 3-4. Fan status light - late 2005 and later
Color
Condition
Indicates
Red
ON
There is in a fault state.
Green
ON
The fan is active and operating normally.
Green
BLINKING
The fan is initializing.
