Installing and Removing Modules
Replacing the fan tray
Stinger® FS/Stinger FS+ Getting Started Guide
6-11
Figure 6-8. Air filter removal
5
In the front of the chassis, remove the 10 screws that hold the air intake screen in
the front of the chassis. Then remove the intake screen and the air filter, as
shown in Figure 6-8.
Figure 6-9. Power filter retaining nuts
6
Locate the four retaining nuts for the power filter that you are removing and
remove them from the threaded retaining studs. (See Figure 6-9.)
7
Completely loosen the three latching screws along the bottom of the power that
you are removing. (See Figure 6-7.)
8
Firmly grasp the extraction handle on the power filter and pull to remove the
power filter from its location in the chassis. (See Figure 6-7.)
Note
It may be necessary to rock the power filter from side to side while pulling
on it, to loosen it.
Power filter retaining
nuts (shown for power
filter A)
