Lucent Technologies STGRCR-ELIM-AP-48, Module Manual, Page: 65 / 100

Examples for configuration of ADSL2+ line
codes
Configuration Examples
............................................................................................................................................................................................................................................................
363-217-018R9.8
Issue 1, August 2005
4 - 5
Configuration for ADSL2+
Setting the
line-code
in the
line-config
subprofile to
adsl2plus
will configure an al-dmt
port to attempt to use the ADSL2+ protocol (ITU-T G.992.5). The line will attempt to use
this protocol and will not train if it is unsuccessful.
r e a d a l - d m t { 1 1 1 }
s e t e n a b l e d = y e s
s e t l i n e - c o n f i g l i n e - c o d e = a d s l 2 p l u s
s e t l i n e - c o n f i g r a t e - a d a p t - m o d e - u p = a u t o m a t i c - a t - s t a r t u p
s e t l i n e - c o n f i g r a t e - a d a p t - m o d e - d o w n = a u t o m a t i c - a t - s t a r t u p
s e t l i n e - c o n f i g l i n e - l a t e n c y - d o w n = i n t e r l e a v e
s e t l i n e - c o n f i g l i n e - l a t e n c y - u p = i n t e r l e a v e
s e t l i n e - c o n f i g d o w n s t r e a m - e n d - b i n = 5 1 1
w r i t e
Important!
Increased line rates that are possible with ADSL2+ LIMs will not be
realized unless the
down-stream-end-bin
setting is set above the default value of 255.
Under most conditions the optimum setting is 511.