System Reset to Factory-Set Values-0
CAUTION: Use of reset eliminates all customization.
If you dialed 0 in STEP 5 on page 13, and if all telephones except the one you are using are idle,
you can reset the system to the installed settings shown on the chart on pages 10-11. If all telephones
are not idle, you will hear the busy signal.
Enter the System Reset code 09009. If you make a mistake you will hear the error tone, and
you must exit and re-enter reset to try again (press ENTER ADMIN and dial 0). If you enter
the reset code successfully you will hear the confirmation tone and and all features except
System SpeedCall numbers and call report day and time will be returned to installed settings.
Lines 1 through 12 again will be assigned to buttons 1 through 12 on all telephones. If any
telephones were customized so that some of those buttons were multi-purpose, and those
buttons were programmed by the users, one-touch access to Personal SpeedCall numbers and all
other user programming for those buttons will be lost. User programming of buttons 13 through
24 will be unaffected.
The reset procedure requires up to five seconds. You will hear the confirmation tone after the
procedure is completed.
To exit you may replace the receiver or press SPEAKER, or, if you want to continue customizing
features, press the ENTER ADMIN button to reenter administration at STEP 5 on page 13.
14 Administration Manual
