Lucent Technologies SLC-2000 Access System Central Office Terminal, Assembly Manual

Page: 125 / 284

363-208-010
Cabling, Wiring, and Assembly
Issue 5 May 1997
3-59
Connections
Step 1: Install the VF Interface Cable Assemblies in the appropriate duct and
mate their connectors with the connectors of the MDS Cable Assemblies
in accordance with Figures 3-30 and 3-31 and the table below:
Table 3-4. VF Connections
NOTE
:
Stamp each connector (J101 to J204) before mating to its
associated connector.
Step 2:
Terminate the VF pairs at the MDF and label the cables, connectors, and
the conductors in accordance with the figures for the J101 to J104 and
J201 to J204 connectors. Note the wire color coding sequence of the
factory prepared cable assemblies to facilitate the terminations.
Table 3-5. VF Channel Number Identification
Step 3: Orient the mating cable connectors so that the customer cables exit
upwards towards the cable racks. Refer to Figure 3-31.
Left Cable Duct Right Cable Duct
J101 to P101 J201 to P201
J102 to P102 J202 to P202
J103 to P103 J203 to P203
J104 to P104 J204 to P204
Left Cable Duct Figure Right Cable Duct Figure
J101 to P101 3-32 J201 to P201 3-36
J102 to P102 3-33 J202 to P202 3-37
J103 to P103 3-34 J203 to P203 3-38
J104 to P104 3-35 J204 to P204 3-39