Lucent Technologies PortMaster 4, Configuration Manual

Page: 119 / 191

Using External Modems 9-5
Configuring Ports for Modem Use
Associating a Modem with a Port
To automatically configure a modem and associate it in the modem table with the port
it is attached to, use the following commands:
Command> set C0|all modem-type ModemName(short)
Command> reset C0|all
For example; to associate a U.S. Robotics V.34 modem with port C0 and configure the
modem, enter the following commands:
Command> set C0 modem-type usr-v34
Command> reset C0
To configure all ports for the same modem type, use all instead of the port number in
the previous example. After the modem is attached to the port, configure the other
modem settings described in “Configuring Ports for Modem Use” on page 9-5.
To configure the modem not to answer when users dial in, set C0=0 in the initialization
string.
Configuring Ports for Modem Use
The modem settings described in this section are configured for each port and must
match the configuration on the attached modem.
usr-v32-p USR
Courier/Sportster
V.32bis PCMCIA 57600 AT&F1&W
usr-v34-p USR
Courier/Sportster
V.34 PCMCIA 115200 AT&F1S0=1&W
usr-v32 USR
Courier/Sportster
V.32bis 57600 AT&F1S0=1&W
usr-v34 USR
Courier/Sportster
V.34 115200 AT&F1S0=1&W
usr-spt-v32 USR Sportster
V.32bis 57600 AT&F1S0=1S10=20S13.0=1&W0
usr-spt-336 USR Sportster 33.6 115200 AT&F1S0=1S10=20S13.0=1&W0
zyxel Zyxel U1496E 57600 AT&FM0&D2S0=1S2=1
Table 9-1 Factory Default Modem Table Entries (Continued)
Modem Name
(Short) Modem Name
(Long) DTE
Rate
Initialization String