Lucent Technologies Definity Audix System, Installation And Upgrade

Page: 93 / 208

Task 17: Check the Status of the Switch Names Audit
Issue 2 December 1996
3-35
Task 17: Check the Status of the
Switch Names Audit
This task is required if the system is using DS integration. Otherwise, skip to
Chapter 4, ‘‘Acceptance Checks’’.
The purpose of this task is to check the status of the switch names audit
operation initiated in Subtask 14K: Run the Switch Names Audit.
1. With the cursor on the DEFINITY AUDIX command line, enter status audit
and press .
The system responds with the Audit Results screen showing the result of
the most recently run audit.
2. Check the Result field for the Switch Names audit. If it displays Passed,
proceed to Step 3. If it displays Running, wait a few minutes and repeat
Step 1. Repeat Steps 1 and 2 until the audit screen displays Passed, then
proceed with Step 3.
If the audit does not complete successfully, see DEFINITY AUDIX
System — Maintenance , 585-300-110.
3. Once the audit passes, type display administration-log at the DEFINITY
AUDIX command line and press .
RETURN
RETURN