Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 826 / 2536

RESET 2 of 1 Page RESET
NAME
Program Software System the Reset reset:
FORMAT INPUT
reset
;
DESCRIPTION
!
CAUTION:
data. performance-monitoring affect may command this of Execution
and history All program. software system the resets command This
and lost is information alarm All lost. is data performance-monitoring
end far the from "rediscovered" and lost are time and date The "rediscovered."
( default to set or
70-01-01
and date for
00:00:00
provisioning No time). for
in parameter length page the for except changed, or lost is information
set-
link
value. default the to reset is which ,
date the reading by place takes process recovery time and date automatic An
shelf local the of interface main the to connected shelf remote the from time and
recovered is data time and date the applications, ring In applications). linear (in
shelf. local the main-1 to connected shelf remote the from
1: NOTE
name command this of version abbreviated an commands, other Unlike
name command complete the type must user The entered. be not may
denied. be will request command the or command this entering when
2: NOTE
this then shelf, a on port DCC or CIT any on enabled is security If
on ports DCC or CIT all for only users privileged to available is command
shelf. the
3: NOTE
other the at (shelves shelves adjacent all shelf, any on done is reset a If
may reset) being shelf the on terminate that interfaces optical the of ends
normal a is This alarms. failed" channel DCC "section transient show
response. system
11-156
2000 February 2 Issue
OC-3 DDM-2000