Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1148 / 2536

SET-TRACE-STS1 3 of 1 Page SET-TRACE-STS1
NAME
Characteristics Trace Path STS Set set-trace-sts1:
FORMAT INPUT
set-trace-sts1
:
Address
[:
EXPTRC= Expectedincomingpathtrace
]
[,
TRC= OutgoingPathTrace
];
DESCRIPTION
the to strings character alphanumeric user-selectable assigns command This
signal. STS-1 cross-connected STS an of fields trace path receive and transmit
through "a" and "Z" through "A" letters the include characters ASCII allowed The
characters: special following the and "9", through "0" numbers "z",
sign) (dollar $ sign) (pound #
(ampersand) & sign) (percent %
parenthesis) (close ) parenthesis) (open (
(asterisk) * (plus) +
(hyphen) - (pipe) |
bracket) square (close ] bracket) square (open [
bracket) (close } bracket) (open {
accent) (grave ‘ (apostrophe) ’
(slash) / (period) .
than). (greater > than) (less <
NOTE:
circuit BBG4B a to terminating paths STS to applicable only is feature This
pack.
are: parameters input The
Address
terminating path SONET the of address channel STS-1 a is This
assigned. is trace path the which for signal
OC-3): (within Addresses Valid
{m,c}-{1-3},{a,b}-{1,2}
Release (OC-3 29-type or 24-type with equipped is shelf the If
unit Main valid the slots, unit Main its in packs circuit OLIU 15.0)
are: addresses
m-{1-12}
Addresses: Only Rings Valid
m-{1-3}
Addresses: OLIU 27-type Valid
m-{1,2}
EXPTRC
is It message. trace path incoming expected the specifies EXPTRC
characters. alphanumeric less or 62 of string a
11-478
2000 February 2 Issue
OC-3 DDM-2000