Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1141 / 2536

SET-T3 7 of 1 Page SET-T3
NAME
Characteristics T3 Set set-t3:
FORMAT INPUT
set-t3
:
Address
:[
md= Mode
][,
ais= AlarmIndicationSignal
][,
alm= AlarmLevel
]
[,
fth= FailureThreshold
][,
pmmd= PMMode
][,
frame= Frame
][,
fmt= Format
];
set-t3
:
Address
:[
alm= AlarmLevel
][,
aisalm= AISAlarmLevel
]
[,
fth= FailureThreshold
][,
pmmd= PMMode
][,
frame= Frame
]
[,
fmt= Format
][,
xbit= Xbit
];
pack) circuit TMUX BBG20 later, and 13.0 Release OC-3 (For
DESCRIPTION
!
CAUTION:
service. affect may command this of Execution
ports. DS3 more or one of parameters characteristic the sets command This
and conditions, AIS thresholds, failure levels, alarm include characteristics These
monitoring. performance
are: parameters input The
Address
or One provisioned. be to port(s) DS3 the of address the is Address
BBG19 with equipped groups Function specified. be may ports all
the in slot each for ports independent have packs circuit DS3
function the for provisioned parameters howerever group; function
ports. both to applied are group
Addresses: Port DS3 Valid
{a,b,c,all}
md
signal. DS3 the of mode removal monitor violation the is Mode
pack circuit TMUX BBG20 the to applicable not is parameter This
have may parameter This releases). later and 13.0 Release (OC-3
values: following the of one
vmr
value). (default errors bit P DS3 remove and Monitor
vm
errors. bit P DS3 remove not do but Monitor
cc
bit P DS3 remove or monitor not Do — channel Clear
errors.
to set is parameter this If
vmr
or
vm
the ,
ais
not will parameter
for. prompted be
to set is parameter this If
cc
the ,
pmmd
,
frame
and ,
fmt
the case, this in Also used. be not will parameters
pmmd
,
frame
,
and
fmt
current The values. current their keep will parameters
the whether used be to available be will parameters both for values
of value
md
to set is
vm
or
vmr
.
OC-3 DDM-2000
2000 February 2 Issue
11-471