Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1116 / 2536

SET-STATE-T1 2 of 1 Page SET-STATE-T1
NAME
State Port T1 Set set-state-t1:
FORMAT INPUT
set-state-t1: Address:ps=PrimaryState
;
DESCRIPTION
on turn to used is command This ports. DS1 of state the sets command This
port. specified a from failures signal to due alarm the off and
NOTE:
TMUX the within DS1s "internal" the to applicable not is command This
later. and 13.0 Release OC-3 in available is that pack circuit (BBG20)
exists there if only set be may state port DS1 packs, circuit LAN IMA using When
the at denied be will request the otherwise DS1; that on cross-connect VT1.5 a
level. prompt user
are: parameters input The
Address
port(s). DS1 the identifies Address
Addresses: Valid
{a,b,c}-{1-7,all}-{1-4,all} all,
two supports 15.0) Release (OC-3 pack circuit (BBF6) T1EXT The
1 numbers port only BBF6, a on ports addressing When ports. T1
Specifying valid. are 2 and
all
only. 2 and 1 ports selects
ps
following the of one have may which state port the is PrimaryState
values:
auto
the at signal good for monitored be to state Set
port. specified
nmon
monitored). (not alarmed" "not to state Set
NOTE:
the in is port a If
nmon
the to returned be must it state,
auto
(using state
be can port that with associated packs circuit any before command) this
the by list equipment the from removed
upd
command.
is state primary interface’s LAN the pack, circuit LAN IMA the using When
pack. that on provisioned is state primary DS1’s first the when set automatically
11-446
2000 February 2 Issue
OC-3 DDM-2000