Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1097 / 2536

SET-SECU 7 of 1 Page SET-SECU
NAME
Security Set set-secu:
FORMAT INPUT
set-secu
:
Address
[:[
sec= Security
][,
to= Timeout
]};
set-secu
:
Address
[:[
porttype= Porttype
][,
baudrate= Baudrate
]
[,
echo
=
echo
][,
sec= Security
][,
to= Timeout
]];
later) and 15.0 Release (OC3
DESCRIPTION
CIT each on security system (NE) element network configures command This
also will command this 15.0, Release OC-3 with Starting interface. DCC and
CIT rear/front the from messages TL1 transmit and/or receive to user the allow
to interface synchronous X.25 the change to allowed be also will user The ports.
asynchronous
are logins default three The
LUC01
,
LUC02
and ,
LUC03
upper-case (all
is password default The letters).
DDM-2000
change should users Privileged .
state. lockout a to security setting or security enabling before defaults these
NOTE:
only. users privileged to available is command This
are: parameters input The
address
ports. DCC and/or CIT more or one of address the is Address
address. default no is There
Addresses: Valid
cit-{1,2,all} dcc-all,
interfaces): (OC-1 Addresses Valid
dcc-all
is: interface X.25 for Address Valid
x25
later) and 15.0 Release (in
porttype
Address provisioned the whether Specifies
cit-1
- port (DCE
or access) front
cit-2
for used is access) rear - port (DTE
CIT
or
TL1
is Address of value the If application.
cit-2 or cit-1
,
values: possible two have can parameter this
cit
or
tl1
.
is value Default
cit
.
is Address of value the If
x25
two have can parameter this ,
values: possible
synch
or TL1), for type port (default
asynch
.
is value Default
synch
.
TL1 run to provisioned be can CIT-2) or (CIT-1 port CIT one Only
type port CIT-2’s TL1, as provisioned is type port CIT-1’s if (e.g,
a otherwise vice-versa), and TL1, run to provisioned be cannot
later). (defined displayed is message denial
OC-3 DDM-2000
2000 February 2 Issue
11-427