Lucent Technologies Cajun P220, Operation Manual

Page: 102 / 335

Configuring IPX Routing (Layer 3)
4-6 Cajun P550/P220 Switch Operation Guide
5. Click CREATE to save your changes or CANCEL to restore previous settings.
Creating IPX Static Routes
To create IPX static routes:
1. From the IPX Configuration section of the Web Agent window, click Static
Routes . The IPX Static Routes dialog box opens.
2. Click CREATE . The Add IPX Static Route dialog box opens.
3. Use Table 4-4 to complete your configuration:
4. Click CREATE to save your changes, or CANCEL to restore previous settings.
SAP Enable or disable IPX SAP on a selected interface.
Type 20 Packet
Propagation Specify whether or not Type 20 packets can be sent, received,
disabled, or sent and received on a given interface.
Options include:
• Disable - Type 20 packets are neither sent nor received.
• Inbound - Type 20 packets are received.
• Outbound - Type 20 packets are sent.
• Both - Type 20 packets are sent and received.
Table 4-4. IPX Static Route Parameters
Parameter Allows you to specify the...
Network Number of the IPX network (in hex) you want to assign to the IPX
static route.
Next-Hop Node MAC address of the next destination to which the packet is routed.
Format of the value to enter is
aa:bb:cc:dd:ee:ff .
Interface IPX Interface associated with the next hop.
Ticks Amount of time (in ticks) that the packet takes to reach the
network number you specified. A tick is approximately 1/18th of a
second.
Hops Number of routers (hops) that the packet must pass through before
reaching the network number associated with the IPX network.
Table 4-3. IPX Interface Parameters (Continued)
Parameter Allows you to...