Lucent Technologies CAJUN M770, User Manual

Page: 90 / 266

Chapter 6 Managing Virtual Ports
72 Cajun M770 ATM Switch User’s Guide
Listing the status information for all virtual ports
You can view the status information for all virtual ports that exist or for a specific
virtual port.
Any virtual port information that is marked with an asterisk (*) has been learned
by the M770 ATM Switch during the ILMI dialogue with the remote device.
Information that is not marked with an asterisk has either been configured by the
user or is the default setting for the virtual port.
To view the virtual port status, enter the
vport show status
command.
Sig VPCI Base The signalling VPCI base on a non-root virtual port.
Command:
M15-155s8:/>vport show status [<vport id>]
Parameter:
<vport id>
The virtual port. This is displayed in the format
<slot>.<port>.<virtual port number>.
If a <vport number> parameter is not supplied then the link
status summary information is supplied for all virtual ports.
Example:
M15-155s8:/>vport show status
Output:
Virtual Port Status Information
Virtual Admin Oper
Stack User Q.SAAL Q.2931 PNNI-Hello ILMI ILMI
Port Id State State Type /Net State State State Ver State
8.0.0 Up Up Internal User Up Up Down 4.0 Disabled
8.1.0 Up Down PNNI 1.0 Net Down Down Down 4.0 Inactive
8.2.0 Up Up UNI 3.1* Net* Up Up Down 3.x* Ready
8.3.0 Up Up UNI 4.0* Net* Up Up Down 4.0* Ready
8.4.0 Up Up PNNI 1.0* Net* Up Up Up 4.0* InterSwitch
Table 6.3 Output from the vport show vpivciranges command (Continued)
Field Description