Lucent Technologies CAJUN M770, User Manual

Page: 59 / 266

Chapter 5 Managing Physical Ports
Cajun M770 ATM Switch User’s Guide 41
Disabling a physical port
Before any physical port parameters can be changed, cleared, or reset, you must
disable the physical port. To disable a physical port, use the
pport
disable
command.
Enabling a physical port
To enable a physical port, use the
pport enable
command.
Setting physical port parameters
You can set individual parameters for a physical port. Once a physical port
parameter has been set, ILMI will not override the parameter when the physical
port is re-enabled.
You can set the following parameters for a physical port:
•
payload scrambling
• framing
• transmit rate capping
Note:
Before any physical port parameters can be changed, cleared, or reset, you
must disable the physical port. For more information about how to disable a
physical port, see Disabling a physical port earlier in this chapter.
To set a parameter for a physical port, you must perform the following steps:
1 Disable the physical port.
2 Set the parameter for the disabled physical port, as required.
3 Enable the physical port.
Command:
M15-155s8:/>pport disable <pport id>
Example:
M15-155s8:/>pport disable 8.1
Parameter:
<pport id>
The physical port identifier in the
form <slot>.<port number>.
Command:
M15-155s8:/>pport enable <pport id>
Example:
M15-155s8:/>pport enable 8.1
Parameter:
<pport id>
The physical port identifier in the form
<slot>.<port number>.