Lucent Technologies CAJUN M770, User Manual

Page: 249 / 266

Appendix B Using BOOT Loader
Cajun M770 ATM Switch User’s Guide 231
Note:
Set up of new calls has priority over the XMODEM upload, so on a busy
network it may be necessary to disconnect the M770 ATM Switch from the network in
order to achieve a successful upload via the bootloader.
Uploading over tftp
In order to upload over TFTP (Trivial File Transfer Protocol), the remote file server
must be accessible from the MSPV/MSPX Ethernet Sideband port. To verify this
connectivity you should ping from the file server to the IP of the MSPV/MSPX.
To upload a file over TFTP, use the
system upload tftp
command.
Note:
The main purpose of upload command is to save configuration files on a source
other than the M770 ATM Switch.
Rebooting the switch
It is highly recommended that you use the
system reboot
command to reboot the
Cajun M770 instead of using the reset button. This is because the
system reboot
command first flushes any outstanding configuration updates to the non-volatile
memory, whereas pressing the reset button may cause configuration information to
be lost.
Command:
M15-155s8:/>system upload tftp <ip_address> <flashfile>
<destination_filename> [<gateway>]
Example:
M15-155s8:/>system upload tftp 194.31.222.23 m770ATM m770ATM_new
Parameters:
<ip_address>
The IP address of the remote TFTP
server.
<flashfile>
The full name of the file in flash
memory.
<destination_filename>
The full destination file name on the
remote TFTP server. If the file is
contained in a sub-directory, the
complete path and filename must be
supplied.