Lucent Technologies CAJUN M770, User Manual

Page: 218 / 266

Chapter 17 Managing System Commands
200 Cajun M770 ATM Switch User’s Guide
Enabling the pager
If the pager is enabled, the M770 ATM Switch displays output on the terminal screen, a
number of lines at a time. To enable the pager, use the
terminal pager enable
command.
Disabling the pager
If the pager is disabled, the M770 ATM Switch displays output on the terminal screen
continuously. To disable the pager, use the
terminal pager disable
command.
Viewing the number of lines
If the pager is enabled, this is the number of lines that the M770 ATM Switch will
output before pausing. For more information about the pager, see Viewing the prompt
later in this chapter.
By default, the number of terminal lines is set to 24.
To display the current number of lines, use the
terminal lines
command.
Setting the number of lines
To set the number of lines, use the
terminal lines
command.
Command:
M15-155s8:/>terminal pager enable
Output:
pager enabled
Command:
M15-155s8:/>terminal pager disable
Output:
pager disabled
Command:
M15-155s8:/>terminal lines
Output:
terminal ines: 24 (auto-detected)
or
(user-configured)
Command:
M15-155s8:/>terminal lines <rows>
Example:
M15-155s8:/>terminal lines 48
Parameter:
<rows>
The number of lines to be displayed on the
terminal.