Installation Instructions
2 |
P a g e
v 1 . 0 ( 0 6 / 2 0 2 2 )
Installation Directions
1.
Remove all packaging material from the portable luminaire.
2.
Place the portable luminaire on its side to help with assembly and ensure it is on a smooth non-scratch surface.
3.
Attach the top section of the luminaire (A) onto the middle section of the luminaire (H) and secure by tightening the
grub screw (G) with the allen key (F) provided.
4.
Install the middle section of the luminaire (H) onto the bottom section of the luminaire (K) and secure by tightening
the screw (I) and the knob (J).
NOTE:
Take care not to cross-thread or twist and damage the cord during assembly. Pull the cord out from the
bottom section of the luminaire (K) as you assemble. Continuously check the cord during installation and
relieve any twist in the cord by turning it in the opposite direction.
5.
Keep the portable luminaire on its side, and attach the end cap (N) onto the bottom section of the luminaire (K) and
install the base (O).
6.
At the bottom of the base install the grooved washer (P), followed by the flat washer (Q), spring washer (R) and secure
them all with the hex bolt (S) using the spanner provided (T).
7.
Install the non-scratch cover (U) onto the bottom the base (O).
8.
The portable luminaire can now be placed in an upright/vertical position.
9.
Remove the lamp holder ring (C) and the decorative lamp holder cover (D) from the lamp holder.
10.
Install the lamp shade (B or V - sold separately) onto the lamp holder and secure it with the lamp holder ring (C)
followed by the decorative lamp holder cover (D).
NOTE:
The lamp shade is sold separately and is compatible with the BOND range (B - SKU#269321, 269322) or
the DARLY range (V - SKU# 099081, 099082, 099083, 099084, 099085, 099086) of shades.
11.
Install a globe (E - not included) into the lamp holder. Do not exceed the maximum wattage rating.
12.
Select a suitable location for the portable luminaire. See the installation requirements above.
13.
Adjust the lamp holder or shade to your desired position.
NOTE:
Do not adjust the lamp holder head more than 90
and do not rotate the lamp holder head more than 330
,
as this may damage the knuckle joint or damage the internal wiring.
14.
Insert the plug (L) into the mains power socket outlet and ensure it is fully plugged in.
15.
Turn the power on at the mains power socket outlet.
16.
Use the cord line foot switch (M) to turn the portable luminaire ON/OFF.
