lubemate by macnaught
| Instruction manual
6.5L MANUAL WASTE OIL EXTRACTOR
L-OE6
INSTRUCTION MANUAL
INTRODUCTION
Please read and retain this instruction sheet to
assist you in the operation and maintenance of
your new Manual Waste Oil Extractor.
Suitable for extracting all types of engine oils,
transmission fluids, lubricants, from motor cars,
motor bikes, marine engines, stationary engines,
large and small industrial machinery, as well as
non lubricants such as water from fish tanks, etc.
Size:
647.7mm (H) x 184.15mm (W)
Max. Operating temperature:
100°C
Capacity:
6.5 Litres
Supplied with three tubes
:
• 9.8mm OD x 1m
• 6.7mm OD x 0.85m
• 5.8mm OD x 0.85m
SPECIFICATIONS
Oil Inlet / Outlet
& Main Tube
Connection
Pump Handle
Carry Handle
Release Valve
Button
Tubing Set
Holder
FEATURES
IMPORTANT
Prior to re-using the oil extractor, ensure to press
the “Release Valve” for at least 5 seconds. This
will release any vacuum that may have formed in
the inner pump tube.
DO NOT
use the unit to extract, siphon or store
gasoline or other highly inflammable liquids
DO NOT
use the unit to extract of store
dangerous chemicals, poisons, acids, alkaline or
solvents. If by any chance, liquids such as these
are used in the unit, it must be immediately,
drained, washed and cleaned
DO NOT
store either the unit or suction tubes near
or in areas of high temperatures, direct sunlight,
rain or snow.
DO NOT
drop, throw or mishandle the unit
DO NOT
dismantle, tamper with or adapt the unit
for any other purpose than what it was originally
intended for.
1. Remove the oil dipstick
2. Select an appropriate diameter
extracting tube then connect with the main tube
and insert into dipstick when the engine is
stationary.
3. Pump the handle several times to start the
vacuum and watch the cylinder fill up.
4. Once extraction is completed pour the extracted
oil into an appropriate
container
OPERATION
CAUTION
For Warranty Terms and Conditions refer to
www.lubematebymacnaught.com.au
