LAL 1474
Assembly Instructions
Form. LT013 – rev. 00 - 06/06/2017
page
2
of
3
S
TEP BY
S
TEP TO ASSEMBLE THE FIXTURE
.
Always use UL certified products.
01 – Take the body and Install the suspension
kit. Screw the pins of the suspension on the
back of the body.
02 – Install the driver and the ground wire inside
of the body of the fixture.
03 – Connect the power cable plugging the
“strain relief” in the back of the body. After you
should make the AC and dimming connections.
04 – Fix the LED board into the LED chassis using
the screw number 06.
The fixture 2 and 4 FT have one LED chassis per fixture but
the 8 FT has 2 LED chassis per fixture.
05 – Make the connection between driver and
LED boards, use connectors UL approved.
Do not forget to follow the wire diagram that is
explained in the cut sheet of the product to make
the connections.
06 – Screw the LED chassis in the body.
Remember that the LED boards are already
connected with the driver and with the external
power cable.
In this case you will have two LED chassis in the fixture 8 FT,
however, for 2 and 4 FT fixture you have only one LED
chassis per unit.
