Zhengzhou Linghang Robot Co.,Ltd
26
8.Thoroughly remove lubricant and debris from bearing seat rings and
bushings on tool tray with a clean cleaning cloth.
Note: Lubrication is not required on the tool plate assembly.
9.Start for normal operation.
5.3 Inspection and cleaning of electrical modules
For details, please refer to
《
LTC Electrical Module Instruction Manual
》
.
6.
Troubleshooting and service procedures
The following section provides fault diagnosis information and
troubleshooting service flow for the quick change tooling device.
Warning: All energy connections (e.g. electrical, air, etc.) are
turned off unless the tool is safely supported or placed in the tool
holder; Otherwise, do not maintain or repair the tool changer or
