______________________________________________________________________________
Choose a safe mounting location, so as to prevent the cables can be
stepped on or create tripping hazards.
Before making
mixer volume is turned down.
Connection are made via 3
Before making connection between mixer and active speaker, make sure all
the switches of the speakers are turned off and the mixer volume is turned
down. To avoid a s
first and then the speakers. Turn on the amplifier by the power switch to
position 1 (on).
When the system will start turn on 3 LEDs, after a few seconds will stay on
only two or three if the input si
start with the preset the previously loaded.
You can now use the system.
If necessary, adjust the volume by adjusting the potentiometer.
If you want to change the preset, follow the instruction below.
LOADING A
The active preset is indicated by the corresponding LED. It is possible to
change presets by pressing the center pushbutton
P1 –
P2 –
P3 –
P4 –
______________________________________________________________________________
Operating Manual ver.
Choose a safe mounting location, so as to prevent the cables can be
stepped on or create tripping hazards.
Before making connections between mixer and speakers, make sure
mixer volume is turned down.
Connection are made via 3-pin XLR connector.
Before making connection between mixer and active speaker, make sure all
the switches of the speakers are turned off and the mixer volume is turned
down. To avoid a sudden signal, making connection, then turn on the mixer
first and then the speakers. Turn on the amplifier by the power switch to
position 1 (on).
When the system will start turn on 3 LEDs, after a few seconds will stay on
only two or three if the input signal is present, when the amplifier turn on,
start with the preset the previously loaded.
You can now use the system.
If necessary, adjust the volume by adjusting the potentiometer.
If you want to change the preset, follow the instruction below.
LOADING A PRESET
The active preset is indicated by the corresponding LED. It is possible to
change presets by pressing the center pushbutton P.
– preset 1 (green): indicates the factory presets SMOOTH
– preset 2 (green): indicates the factory presets VOCAL
– preset 3 (green): indicates the factory presets LOUD
– preset 4 (green): indicates the factory presets FLAT
______________________________________________________________________________
Operating Manual ver. SF15DC-EN-1.0 |13
Choose a safe mounting location, so as to prevent the cables can be
connections between mixer and speakers, make sure the
Before making connection between mixer and active speaker, make sure all
the switches of the speakers are turned off and the mixer volume is turned
udden signal, making connection, then turn on the mixer
first and then the speakers. Turn on the amplifier by the power switch to
When the system will start turn on 3 LEDs, after a few seconds will stay on
gnal is present, when the amplifier turn on,
If necessary, adjust the volume by adjusting the potentiometer.
If you want to change the preset, follow the instruction below.
The active preset is indicated by the corresponding LED. It is possible to
.
SMOOTH
VOCAL
LOUD
FLAT