LSILogik eXtreemeRAID 3000, Quick Installation Manual

Page: 13 / 24

Manual No. DB11-000034-00 1
Hardware Installation
Introduction
The eXtremeRAID 3000 is a very versatile PCI to Fibre Channel RAID
controller with an internal Ultra2 SCSI, LVD channel. There are many
possible hardware configurations. This quick installation guide assumes that
the user is familiar with controller, disk drive, and RAID terminology.
Performing an Installation

WARNING
To avoid electrical shock, do not attempt to
perform this hardware installation with power on.
Disconnect the system from the electrical wall
outlet.
PCI Hot Plug
Please refer to Appendix D in the eXtremeRAID 3000 Installation Guide
for instructions on how to use the PCI Hot Plug feature.
Connectors, Jumpers, and LEDs
There are two Fibre external channels supported on the controller. There is
one Ultra2 SCSI internal channel that is supported on the controller. The
SCSI and Fibre connector locations are shown in Figure 1.
The back side of the controller has eight LEDs that are active indicators
while the controller is running. Please see Figure 2 for the complete
identification and location of the LEDs.
All the jumpers should normally be set to their default settings. Jumper
locations are shown in Figure 3. Please see Table 1 for default jumper
descriptions.