LSI LSI21002, User Manual

Page: 38 / 86

2-22 Installing the LSI21002
2.2.4.5 Setting SCSI IDs
You must set each SCSI device and the host adapter to a separate SCSI
ID, 0–15 for a 16-bit SCSI. SCSI ID 7 is the preset host adapter setting,
giving it the highest priority on the SCSI bus. If you plan to boot your
computer from a hard disk drive on the SCSI bus, that drive should have
SCSI ID 0, or the lowest SCSI ID on the bus.
Chapter 3, "Configuring the
Host Adapter," explains how to set the host adapter ID using the
LSI Logic SCSI BIOS Configuration Utility.
The peripheral device SCSI IDs are usually set with jumpers or with a
switch on the peripheral. Refer to the peripheral manufacturer’s
instructions and to the user’s manual for your computer to determine the
ID of each device and how to change it. You must have no duplication of
SCSI IDs on a SCSI bus.
Note: SCAM support is turned off by default for the BIOS version
4.11.00 and above. You may choose to turn this on to assist
in assigning SCSI IDs.
Determine the SCSI ID of each device on the SCSI bus. Note any
duplications.