LSC Lighting Systems (Aust) Pty Ltd.
Page 2
monoPAK Single channel portable dimmer
monoPAK Single channel portable dimmer
monoPAK Single channel portable dimmer
monoPAK Single channel portable dimmer
Using the monoPAK
Using the monoPAK
Using the monoPAK
Using the monoPAK
Before using the monoPAK on your selected load, it is important to confirm that the power
required by the load does not exceed the output power rating of the monoPAK dimmer
(2400Watts@240Volts AC), otherwise the dimmer could be damaged.
The monoPAK is a versatile single channel 10Amp dimmer suitable for followspots, stage
props, photography studios, film locations, retail outlets, trade exhibititons etc… The integral
cables allow the monoPAK to be installed in series between an AC power source and a
dimmable load. Adjusting the sliding fader varies power to the load.
The load should NOT be connected or removed while the monoPAK is supplying power to the
load. Always adjust the sliding fader to the minimum position (0 power level) before adding
or removing a load.
Technical Specifications
Technical Specifications
Technical Specifications
Technical Specifications
Maximum output load
2400Watts @ 240V input.
Input Voltage Range
200 – 250VAC @ 50/60Hz.
Input Protection
10 Amp HRC M205 Fuse.
Inductor Rise Time
250-300usec (peak to peak).
RF suppression
Input and output filters to CE requirements.
CE and C Tick Approved
Yes.
Dimensions (excluding cables)
255mmL x 94mmW x 73mmD
Weight
4.0kg (5.0kg packed).
Construction
Zinc steel finished in textured black powdercoat.,
Rear silk screened polycarbonate front panel.
Mounting Specifications
Mounting Specifications
Mounting Specifications
Mounting Specifications
(mm)
256.0
234.0
15.0
94.0
47.0