Specifications
All Scenes,Chases, and Options retained by battery back up
3 space 19” rack mount case
Reversible DMX polarity out put
MIDI input to control Chase and scene s
192 DMX Channels output 12 Scanners buttons (up to 16 Channels each)
6 Chases of 240 steps
240 Scenes in 30 Banks
Audio Chase
Speed and Fade time adjustments
LSC® Los Angeles, CA 90058 - DMX OPERATOR User Manual page 17
TROUBLE SHOOTING
Mirrors don’t respond when I move faders
Make sure address is correct. See Chart pages 20, 21
Make sure speed is adjusted, if available, for faster
movement.Not all Fixtures have a speed adjustment.
If total of XLR cable is more than 90 feet make sure it is
terminated properly.
Colors don’t respond when I move faders
Make sure address is correct. See Chart pages 20 21
If total of XLR cable is more than 90 feet make sure it is
terminated properly.
Scenes don’t playback after I record them
Make sure to press MIDI/RECORD BUTTON, before pressing
SCENE BUTTON. LED’s should blink after pressing each
SCENE BUTTON.
Make sure you are in the correct Bank that has scenes
recorded.
Scenes don’t playback correctly like I recorded them
Was Scanner for all fixtures recorded.
Is Fade Time to long for Speed selected?
Make sure you are in the correct Bank that has scenes
recorded
If total of XLR cable is more than 90 feet make sure it is
terminated properly.
Chases don’t playback after I record them
Make sure to press MIDI/RECORD BUTTON, after pressing
SCENE BUTTON. LED’s should blink after pressing MIDI/RECORD
BUTTON.
Make sure you are in the correct Chase that has steps
recorded
If in Auto Mode, is It selected in Display. Did you adjust Speed
after selecting Auto?
Is Fade Time to long for Speed Selected?
If total of XLR cable is more than 90 feet make sure it is
terminated properly.
LSC® Los Angeles, CA 90058 - DMX OPERATOR User Manual page 18
CABLE TERMINATION
When total run of Control cable is 90” or over it is necessary to
terminate the Cable. This can be accomplished as follows.
1: Many Fixtures have some type of built in termination either auto-matic or
by some type of function switch,select this in the last fixture in the link.
2: Make or buy a Termination Plug and insert it into the last Fixture in the
link.
To make a termination plug use a Male XLR plug and solder a 90 to 120
ohm 1/4 watt resistor between pins 2 & 3 of the plug.
