LS Mecapion L7 A001, User Manual

Page: 47 / 222

3. Wiring Method
3-9
3.4.3 Analog Input/Output Signals
1. Keep GND as 0 [V] of control power.
2. Keep the input signal command voltage within ±10 [V], and input impedance at 22 [
㏀
].
3. Output signal voltage for Monitor 1 (No. 28) and Monitor 2 (No. 29) is ±10 [V].
Configure wiring as shown in the following image when you adjust analog input with
parameter resistance by using power supplied by the drive.
Do not exceed the maximum output capacity of 30 [
㎃
].
Input/output
signal
Servo Drive
Input/output signal
AGND AGND
Twisted Pair
Shield Wire
FG
330 [Ω] 1/4 [W]
330 [Ω] 1/4 [W]
5 [kΩ]
0.1 [uF]
+12 [V] (34)
-12 [V] (35)
Analog command
(26), (27), (1)
AGND
(8)