LS ELECTRIC LSLV-H100 Series, User Manual

Page: 166 / 618

153
Learning Advanced Features
5.5 Safe Operation Mode
When the multi-function terminals are configured to operate in safe mode, operation
commands can be entered in the Safe operation mode only. Safe operation mode is used
to safely and carefully control the inverter through the multi-function terminals.
Group Code Name LCD Display Parameter Setting
Setting
Range
Unit
ADV
70
Safe operation
selection
Run En Mode 1 DI Dependent 0-1 -
71
Safe operation
stop mode
Run Dis Stop 0 Free-Run 0
–2
-
72
Safe operation
deceleration
time
Q-Stop Time 5.0 0.0
–600.0 sec
IN
65
–
71
Px terminal
configuration Px Define(Px:
P1
–P7)
15 RUN Enable 0-55 -
Safe Operation Mode Setting Details
Code Description
IN-65
–71 Px
Define
From the multi-function terminals, select a terminal to operate in safe
operation mode and set it to ‘15 (RUN Enable)’.
ADV-70 Run En
Mode
Setting Function
0 Always Enable Enables safe operation mode
1 DI Dependent Recognizes the operation command from a
multi-function input terminal.
ADV-71 Run Dis
Stop
Set the operation of the inverter when the multi-function input terminal in
safe operation mode is off.
When the safety operation mode terminal signal is given, the inverter
decelerates based on the settings at the Q-Stop time. The inverter
decelerates and stops based on the deceleration time (Dec Time)
settings if the run command is off.
Setting Function
1 Free-Run Blocks the inverter output when the multi-
function terminal is off.
2 Q-Stop The deceleration time (Q-Stop Time) used in
safe operation mode. It stops after deceleration
and then the operation can resume only when
the operation command is entered again. The
operation will not begin if only the multi-function